Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KLiK

Pages: [1]
1
TThrottle / Re: Make a donation
« on: October 15, 2017, 09:13:05 pm »
Hi,
would you mind if I send you some Gridcoins, as your program has saved my GPUs & CPUs several times.

Just post an address & I'll send it to you.

Thanks,

2
Translations / I could try out the translation for Croatian!
« on: May 01, 2016, 01:34:52 pm »
Which can also be understood in most of ex-YU, so: Croatia, Bosnia & Hercegovina, Montenegro, Serbia, Kosovo...just let me know & mail me a form to translate!  ;)

3
Questions / Re: Starting TThrottle gives BSOD
« on: April 21, 2015, 09:30:33 am »
7.22 ver also makes the BSOD...all on cputemperature.sys

which version do u suggest for an old WinXP system?
The problem is the CPU driver, so it will never work.

Also, could a 2 processor system be blamed for BSOD with cputemperature.sys ?

'cause BP6 has a 2 processors: http://www.tomshw.it/guides/hardware/cpu/20041220/images/abit_bp6_big.jpg

4
Questions / Re: Starting TThrottle gives BSOD
« on: April 20, 2015, 09:24:10 am »
OK...so the TThrottle needs a P4 processor or newer to work...'cause of the CPU temp sensor!

thx

5
Questions / Re: Starting TThrottle gives BSOD
« on: April 19, 2015, 02:58:06 pm »
7.22 ver also makes the BSOD...all on cputemperature.sys

which version do u suggest for an old WinXP system?

6
Questions / Re: Starting TThrottle gives BSOD
« on: April 18, 2015, 09:37:35 am »
So a CPU without the sensor is not viable for TThrottle?

And that is why i get BSOD on loading TThrottle...

7
Questions / Re: Starting TThrottle gives BSOD
« on: April 17, 2015, 09:09:43 pm »
Also, I noticed that you use "CPU temp" to regulate the temp on the TThrottle.

Is there an older version where you used temp sensors from the MBO?

8
Questions / Re: Starting TThrottle gives BSOD
« on: April 16, 2015, 07:26:31 pm »
It's an old ABIT BP6 board with 2 celerons on 533MHz...
I don't think that the celerons will work anyway.
That may be the reason for the BSOD, the celeron probably doesn't like the temperature request.
What is the slowest family of intel chipset that you have used for TThrottle?
'cause this is Mendocino core: http://ark.intel.com/products/27189/Intel-Celeron-Processor-533-MHz-128K-Cache-66-MHz-FSB

9
Questions / Starting TThrottle gives BSOD
« on: April 16, 2015, 08:27:21 am »
So, even though I've put TThrottle on all my laptops on which it works fine (7.52 for Vista/7/10 & 7.30 for WinXP).

I've come to my good old computer, only one to have to work on less than 100%.
It's an old ABIT BP6 board with 2 celerons on 533MHz...works quite nice & crunches data for WCG, currently mostly OET project...doesn't give me much points, but gives me so much crunching h for the badges! :D

So I've installed 7.30 ver on WinXP & rebooted the system...
After I started the TThrottle, the BSOD becames active & says that "cputemperature.sys" crashed the WinXP...

Has anyone had similar problem?

Pages: [1]